Thursday, November 17, 2011

Tuesday, November 1, 2011

Sprinkler Systems - Landscaping and Fences Can Provide Challenges Irrigation Installers Can Overcome

!±8± Sprinkler Systems - Landscaping and Fences Can Provide Challenges Irrigation Installers Can Overcome

Proper planning is a good start to saving time and money. Preparation and planning a lawn irrigation system and landscape design in the right order can save a lot of headaches. Without a good plan, continuous revising and reworking a layout can increase the costs substantially.

For the home owner considering installing a sprinkler system, installation of all the landscaping elements, plants, and fencing first is strongly recommended. There are several reasons for landscaping being the first step. Often landscapes can alter the drainage, reduce the area requiring irrigation, and actually block certain areas.

One of the first landscaping components to be installed, or at least marked out, is the fencing. While a chain link or wire fence will probably not interfere with any sprinkler spray pattern, the same can not be said of a six foot privacy fence or even a picket fence. Many times a home owner will install a fence after the sprinkler system without being aware that the fence is preventing the lawn from receiving the much needed water.

While one or two sprinkler heads can be relocated with some effort in order to accommodate the above scenario, many times the water coverage will still be insufficient. Depending upon the type of water source, adding several sprinkler heads to an already established layout can reduce the efficiency and water pressure thereby reducing the effectiveness of the entire sprinkler system.

The next order of importance is installing the larger shrubs and bushes. These elements can also block a sprinkler spray pattern, if not at the time of installation then after the plant has matured. A good irrigation designer will take into account the future growth pattern and size of the landscaping. Blocking a sprinkler head with bushes not only prevents the lawn from the necessary water, it can also cause injury to the bush by blasting a stream of water into it.

Some residential and commercial irrigation systems already installed are supplied by municipal water sources. A qualified irrigation installer can usually switch this to a well source almost always allowing the home owner to save money on monthly utilities. The cost of the well can range from 00 to several thousand depending on the region and the type of ground material. Sandy soils are much easier to drill down into than a granite subsurface and therefore less expensive.

Even though there are various models of pumps with different horsepower ratings available, should the property size be on the larger square footage, more than one pump and well may be necessary. Multiple pumps may be able to run off of a single well, but should drought conditions occur and the water table dip near or below the depth of the well bottom, the well will be useless. Damage may befall the pumps as well.

It is always advisable to obtain multiple estimates from a few different irrigation specialists. Asking a lot of questions to each installer will be able to give the home owner a fair idea of the competency and allow the customer to compare one companies services with another. Just because one company undercuts another by a wide margin on price does not mean better quality. Trust in the idiom "you get what you pay for".


Sprinkler Systems - Landscaping and Fences Can Provide Challenges Irrigation Installers Can Overcome

Ag10 Battery Buy Online

Wednesday, September 7, 2011

How to find out the lawn irrigation system

!±8± How to find out the lawn irrigation system

If the spray heads or rotor heads on your lawn sprinkler system when they should pull constantly put down again?

Do not worry, this is a common problem and is most likely caused by several factors. First, what is the age of your sprinklers? Over time (between 3 years and over) causes wear on the corners and edges of the risers, the cause is to attack the head.

The finest sand in the soil, the faster wear belts.The only way to solve this problem is after the head is damaged, replace the head. However, there is another option available to prevent this again. That comes with a sprinkler in stainless steel uprights. I am a bit 'more expensive but will last much longer.

If you have a system that is fairly new and have problems with their heads constantly attacked, you could have dirt in the pipe. The dirt can be entered into the system if you have the repairbreak if the pipe has been installed, or it could just be sediment from the well.

Sometimes leaders can be cleaned easily by stepping down on the mast, while the water and turn on the head. Let it pop back up, then step up again. Do this a few times, then shut down the system and see if the head is still stuck. What are you doing here, cleaning debris from around the seal is at the sprinkler.

The system is a source of water has a lot to do, howoften clogged head. Irrigation systems water the city should not be washed or cleaned nearly as well connected to the sprinklers. Some wells produce water clean enough, while others maintain a high iron content and other impurities that clog the heads and nozzles are quite common causes.

If you have multiple heads, clogged nozzles or glue the ever had, then you might want to flush the entire system. This can be done by removing the nozzles and filtersSpray heads to installing wire and plugs, then the water flows through the system. Caps are flush with the spray heads the first time you buy them. If you do not, you can even completely removing the head and pulling the swing together and then washing is carried out. Please note, this is not the same draining or blowing your system is.

The rotors must be washed in this way anyway. If the system is old and your heads are not installed on swing joints, then onlyMake sure that the rigid PVC riser, that the head was fixed to prevent dirt back into the tube during the rinse dig.

You should also refer to the sprinkler heads to a faucet and clean out. Loosen the inside of the head from the body and rinse the two pieces. When you are finished scrubbing and cleaning the heads, re-install the heads and run the system for about 10 minutes.

Then turn off the system and make sure that all the headswent down. If some crashes, you can mount and just replace them. If you are in sandy soil, I advise you to lift with rotors made of stainless steel. Stainless steel rotors cost about 3-5 times the normal cost of the rotor head, but can be worth their money. Sprays are much less expensive and it is cheaper just to change, rather than purchasing expensive steel uprights.

Just like a car, the sprinkler system to gorequire regular maintenance to keep it running in good condition. The more you neglect your irrigation system, the most damage will be done and will end up costing you more work and money in the long term. An average system will have to wait more than $ 350 per year. So, if you neglect your system for 3 years, expect to pay about $ 1,050 in maintenance costs, when they finally waited.

The amount I mentioned above is only an average value calculated by comparing IHundreds of maintenance over the years, there are several factors that may require maintenance costs more or less. Systems with wells and pumps tend to overall higher maintenance costs than the systems linked to the city or water recovered.


How to find out the lawn irrigation system

Best Buy Rice Krispie Treat Ideas Shop Washi Scissors

Wednesday, August 31, 2011

Toro 53300 1-Inch Sprinkler System Pressure Vacuum Breaker

!±8± Toro 53300 1-Inch Sprinkler System Pressure Vacuum Breaker


Rate : | Price : $54.99 | Post Date : Aug 31, 2011 15:25:40
Usually ships in 24 hours

The Toro 1-inch pressure vacuum breaker prevents the back-siphonage of contaminated water into pressurized, potable water supplies. Economical and easy to install, this atmospheric vacuum breaker makes it simple to winterize with the twist-off cap. The reliable design features a one-inch female NPT inlet and outlet and built-in unions for easy maintenance and easy access to test ports. For new or replacement installations, this pressure vacuum breaker works with any brand of irrigation system.

Best Buy Cuisinart Classic Stainless Cookware Bankers Lamp On Sale

Tuesday, August 16, 2011

X10 IrrMaster Sprinkler Controller, 8-Zone

!±8± X10 IrrMaster Sprinkler Controller, 8-Zone

Brand : Monterey Instruments | Rate : | Price : $139.00
Post Date : Aug 17, 2011 04:55:34 | Usually ships in 4-5 business days


Finally, a full-featured, low priced X10 compatible lawn sprinkler controller! This is a professional system used by office buildings, parks, and golf courses to control sprinkler valves for up to 8 zones. You can combine several IrrMaster units for 16 or more zones! You can use X10 technology on any housecode with HomeBase or any scheduler or manual controller for automated lawn irrigation to increase efficiency and energy savings. The IrrMaster pays for itself in no time! The SafetyZone feature shuts off sprinklers after 80 minutes ... great protection in case your X10 OFF signal doesn't get through! IrrMaster also limits the number of zones that are ON at the same time as protection for your home's sprinkler system against water pressure and valve current draw problems.

More Specification..!!

Best Buy Step2 Sandbox

Friday, August 12, 2011

Install a permanent-ground sprinkler systems save time and water

!±8± Install a permanent-ground sprinkler systems save time and water

They have a very large lawn or floor, a very large lawn equipment? If you do, you probably want to use a live permanently in ground irrigation system, the task of watering the lawn. There are many advantages of a permanent installation, irrigation system in the ground:

1 Full automation

What is constant in ground irrigation system can be connected to a timer and your lawn the water they need, without getting on your part. Just set the timer for the timeDo you want your lawn to collect water (usually in the morning) and you're done.

2 The distribution of water

You decide where your sprinklers are arranged so that your lawn will be watered evenly, without balloting. Of course, this requires some planning and could be a lawn care consultants are committed to help.

3 Saving water

By connecting the permanent, in ground irrigation system, suitable sensors, you can water the lawn only when necessary. ForFor example, you can connect a soil moisture sensor, your permanent, in ground sprinkler system to kick into action when it is not sufficient to detect moisture in the soil.

You can also connect to a rain sensor so that the permanent, in ground irrigation system to automatically turn off when it rains.

4 Flexibility

A permanent, are in-ground sprinkler system gives you lots of flexibility. You have full control over how much water to apply if they apply to that part of waterto water the lawn and the model used for spray irrigation of the lawn.

After making a permanent underground sprinkler system installed, you should still keep an eye on your system to keep it running properly. You may need to adjust the timer to turn the season or if, during the winter.

Observe how your lawn is to react the irrigation system. If any part of your lawn to dry and begin to die and can cause a blockage in the sprinklerHead in this area. If there is too much water in one part of the lawn, may be a leak in the irrigation system.

You should also check your valve to make sure it is not full of water. If so, is probably one of the valves is leaking and must be resolved as quickly as possible. This may be due to a broken seal or worn washer.

Not cheap, permanent, install in-ground irrigation system, but consider the amount of time you can save money, this is an option you shouldserious consideration.


Install a permanent-ground sprinkler systems save time and water

Coach Briefcase Outlet Top Quality !8!# Discount Leaf Blowers Walk Behind


Twitter Facebook Flickr RSS



Français Deutsch Italiano Português
Español 日本語 한국의 中国简体。







Sponsor Links